Moulded Single Drainer Sinktops

These sinktops feature a worktop, sink and sloping drainer moulded as a single seamless section.

Sinktops from this range incorporate a ribbed drainer area which slopes to an integrally moulded sink bowl. The units are cast oversize and then cut to the required size and configuration, from a minimum of 900 x 600 mm up to a maximum of 1500 x 900 mm and at any size in between. They are then fitted with edging from Simmons’ range as required.

Sinktops can be fitted directly onto steel supports or cabinets. There is no need to provide any additional support for these units.

When ordering please clearly state overall size of unit, left or right hand bowl and preferred position of sink within the unit. Any tap holes that are required should also be specified.

Two of these units can be combined to make up a double bowl double drainer sinktop. These would have a central joint machined ready to be jointed on site and would have edging all around the perimeter of the assembly. All jointing materials would be supplied as part of the package.

Please note that these drawings and photos are of these sinktops manufactured at a standard width of 750 mm. Single drainers can be made at any width from 600 mm up to 850 mm at no additional cost.

Moulded Single Drainer Sinktops - Product Dimensions

Sinktop Ref.	Length	Width	Bowl Size	Waste Location
SD900-RHB	900 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD900-LHB	900 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD1000-RHB	901 to 1000 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD1000-LHB	901 to 1000 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD1200-RHB	1001 to 1200 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD1200-LHB	1001 to 1200 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD1400-RHB	1201 to 1400 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD1400-LHB	1201 to 1400 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD1500-RHB	1401 to 1500 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer
SD1500-LHB	1401 to 1500 mm.	600 to 850 mm.	400 x 400 x 300 mm.	Next to drainer

Installation and Maintenance

General Maintenance

As with all worktops a reasonable standard of laboratory housekeeping will help to keep the worktops in good condition. All spillages should be cleaned up as soon as possible. Staining agents and aggressive chemicals should not be allowed to sit in contact with the tops for a prolonged period of time.

Areas of chemical attack or staining can be removed with a polishing compound or very fine abrasive paper, but it should be stressed that this will alter the finish of the surface. Performance will not be affected.

The use of a wax furniture polish will help to retain the gloss finish.

Components should not be exposed to dry-ice or liquid nitrogen and heat insulation pads should be placed between a top and a steambath or hotplate to prevent thermal stress.