There may be some situations in which the standard range of sinktops may not meet a clients' exact requirements. Simmons can fabricate a bespoke sinktop to the size and layout that is required.

The bespoke fabrication service uses standard sheet, sinks, drainers and edgings to provide a sinktop to almost any configuration to satisfy most clients' requirements.

Alternative Drainer Types

Where integral cast drainer areas are not possible or if preferred, drainer areas can also be achieved by:
- Machining drainage grooves in the area adjacent to the sink.
- Applying a thin section drainer board adjacent to a sink.

Specifying Special Fabricated Sink-units

When ordering Special Fabricated Sink-units, please submit a drawing and we will advise how we can best achieve the specification. Please include the following information:

- the overall size of the unit required
- the position / handing of any drainers required
- the size of sink bowl from our standard underslung sink range
- the preferred position of the sink bowl within the unit
- the style of marine edge or upstand from our standard range
- details of any tap holes required (hole diameters & positions)


Drainer Board

Drainer Grooves