Single bowl single drainer sinktops feature a worktop, sink and drainer which is moulded in one section and as such is totally seamless. Sinktops incorporate a ribbed drainer area which slopes to an integrally moulded sink bowl.

Single drainer units are cast oversize and then cut to the required size, from a minimum of 900 x 600mm up to a maximum of 1500 x 850mm. They are then fitted with edging from Simmons standard range to make up the required configuration.

Configuring Single Drainer Sink-Units

When ordering please clearly state overall size of unit, left or right hand bowl and preferred position of bowl within the unit. Any tap holes that are required should also be specified and dimensioned. If necessary you should mark up one of the drawings below with your dimensional requirements including tap holes required.

Diagrams

Right Hand Drainer

Left Hand Drainer

Single Drainer Sink-Unit Sizes

Sink-Unit
Code
Length Width Bowl Position Bowl Position Sink Bowl Size Waste C/L From Rear Waste Position Intenal Radius Weight KG PDF
  A B C D   H R
SD900 900 600 to 850 80 to 100   400 x 400 x 300   Side     download a pdf
SD1000 901 to 1000 600 to 850     400 x 400 x 300   Side     download a pdf
SD1200 1001 to 1200 600 to 850     400 x 400 x 300   Side     download a pdf
SD1400 1201 to 1400 600 to 850     400 x 400 x 300   Side     download a pdf
SD1500 1401 to 1500 600 to 850 175   400 x 400 x 300   Side     download a pdf

All dimensions in millimetres.
Sizes shown are nominal. There can be slight variations from sink to sink due to the nature of epoxy resin.