A selection of Rear Edgings and Upstands.

The rear edge profiles detailed below are used to provide anti-spill edging to special laboratory worktops such as fume cupboards.

Diagrams

No.2 (Rear Edging)

A 15mm high edging, often used in the fabrication of fume cupboard bases. Maximum Length: 2.9m

No.3 (Rear Edging - Standard/10mm)

A 10mm high edging for use against walls or around fume cupboard bases. Designed for use in conjunction with No.1 front edging. Maximum Length: 2.9m

No.3G (Rear Edging - DIN/7mm)

A 7mm high edging used against walls or around fume cupboard bases. Designed for use in conjunction with no.1G front edging. Maximum Length: 3m

No.4 (Wide Rear Edging)

A 15mm high edging available in widths up to 165mm often used in the fabrication of fume cupboard bases. It allows for services to be mounted on top of the edging away from the main worksurface. Maximum Length: 2.5m

No.4A (Wide Rear Edging)

A 10mm high edging available in widths up to 110mm often used in the fabrication of fume cupboard bases. Like No, 4 it allows for services to be mounted on top of the edging away from the main worksurface. Maximum Length: 2.5m

No.5 (Rear Upstand)

With a total height of 40mm and a 15mm bevelled section, this upstand is commonly used against walls or as a deep edging around fume cupboard bases. Often used in conjunction with No.3 and No.4 edges. Maximum Length: 3m

No.6 (Plain Upstand)

Supplied loose with epoxy adhesive for on-site fitment, plain upstand is available at any required height - H, commonly 50mm or 100mm. Often used in conjunction with Marine Edges. Maximum Length: 3m